做工综合要求
General Requirement
1
Sewing workmanship
All stitches should be straight, no seam puckering. Top stitch and bobbin stitch should match with each other, loose or tight is not allowed. Broken stitch, loose stitch, ship stitch, stitch hole is not allowed. Beware of crooked needle tip destroyed the fabricstructure.
车线平整、不起皱、不扭曲。双线部分要求用双针车车缝；底面线均匀、不跳针、不浮线、不断线。不能出现不可恢复性针眼等现象。注意针尖弯曲勾破面料组织。
2
Pen marks and dirty spots
Do not leave any pen mark on cloth, do not use mark pen to rectify labels and carton marks. Oil stain and dirty spot is not allowed on cloth.
画线、做记号不能用彩色画粉，所有唛头不能用钢笔，圆珠笔涂写。内里不能有脏污、抽纱。
3
Color shading and dye lot shadinge
Color shading is not allowed at shell fabric and lining. Dye lot shading in bulk, the bulk need to be packed under certain requirement.
面、里布不能有色差；同批大货有缸差，需要按要求装箱。
4
Accessories
EMB, label, pocket, pocket flap, sleeve tab, pleat, velcro, etc. The size and position should be accurate and symmetrical. Support holes for mark purpose cannot be visible. For EMB, need to trim off all thread ends. For prints, need to make sure no blur, no dirty spot, no see through and no peeling off.
电脑绣花、商标、口袋、袋盖、袖袢、打褶、贴魔术贴等，定位要准确，对 称。定位用的孔不能外露。电脑绣花要求清晰，线头剪清，反面的衬纸修剪 干净，印花要求清晰、不透底、不脱胶。
5
Bar tack
Bar tack should be on position, its thickness should be same as approved sample.
所有袋角及袋盖如有要求打枣，打枣位置要准确、端正。
6
Zipper
Zipper cannot wavy, no blocks when zip up and zip off.
拉链不得起波浪，上下拉动畅通无阻。
7
Drawcord
Exposed drawcord length should based on client’s requirement, if no detailed requirement, the length should not exceed 15cm.
两头出绳的帽绳、腰绳，下摆绳在充分拉开后，两端外露部分应按客户要求（如无，一般不超过15cm），若两头车住的帽绳，腰绳，下摆绳则在平放状态下平服即可，不需要外露太多。
8
Eyelet and rivet
Eyelets and rivets cannot be shape-off. The placement should be accurate, and cannoteasily be pulled off, especially they are on thin fabric, need to pay more attention on the issue.
汽眼，撞钉等位置准确，不可变形，要打紧，不可松动。特别时面料较稀的品种，一旦发现要反复查看
9
Snap button
Snap button placement should be correct, it cannot be too tight or too loose to button up and button off, cannot be shape-off, and cannot be spinning.
四合扣位置准确、弹性良好、不变形、不能转动。
